Hi all,
I plan to make a new router table to hold my new 3.25 hp hulk. A while back I built a router table to attach to my Delta contractors saw. I made a square template to cut the hole. Then I cut a piece of clear plastic and rounded the corners. It was kind of a pain to get a good fit.
What's the best way to cut a hole and then match a plate to fit?
Thanks,
Deck
I plan to make a new router table to hold my new 3.25 hp hulk. A while back I built a router table to attach to my Delta contractors saw. I made a square template to cut the hole. Then I cut a piece of clear plastic and rounded the corners. It was kind of a pain to get a good fit.
What's the best way to cut a hole and then match a plate to fit?
Thanks,
Deck
