Router Forums banner
1 - 1 of 1 Posts

· Registered
1,702 Posts

Have you seen the router workshop series on PBS? They have a very interesting method of using a strip of plastic and a couple of clamps to make a fence that works for a lot of the things you need to do on a table with a router. While most of the expensive fences have dials or other fine tuning methods Bob and Rick opt for a small hammer (fine adjusting tool). Before you spend the big bucks look at the system they use.

In case you have no idea what I'm talking about check out:

Hope this helps,

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.