Hi. Good morning everyone;
I ask for your help.
This puzzle was built by puzzlemaker Eric Fuller.
Does any of you know how to tell with router bitr it is possible to make this finish on the edges of the pieces of this puzzle?
See that each piece has a milling shape on top of the other.
The question remains whether a single router bit was used in one pass, or the same cutter was used in two passes.
Or also if there are two different router bit to achieve this finish.
Summary: how to get this finish with router bit?
And which router bits?
Hugs.
I ask for your help.
This puzzle was built by puzzlemaker Eric Fuller.
Does any of you know how to tell with router bitr it is possible to make this finish on the edges of the pieces of this puzzle?
See that each piece has a milling shape on top of the other.
The question remains whether a single router bit was used in one pass, or the same cutter was used in two passes.
Or also if there are two different router bit to achieve this finish.
Summary: how to get this finish with router bit?
And which router bits?
Hugs.