Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
23,784 Posts
Hi Lee

I made a bracket to hold a P.C. router on my radial arm saw, is yours about the same ????

This one buttons up to the outside of the motor on 4 screws,the same spot you can put on a jig saw. (Radial Saw ,Dewalt/Black and Decker 10")
And you're right it can do many router jobs that the router table can't.

see snapshots below ▼

http://www.routerforums.com/showthread.php?p=84781#post84781

Bj :)
 

Attachments

·
Registered
Joined
·
23,784 Posts
Thanks Lee

Can you please post a snapshot of the mount you have... PLEASE, for the router setup.
The only one I have seen is the one I made for the tail end of the motor.

Thanks
Bj :)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top