Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a large paddle on off safety switch I would like to install in my new router table. Its made by General International and can be wired for different phases and voltages. There are two columns of screws to attach wires to and there are three rows of screws in that two column format (two screws at the top row, two in the middle row and two in the bottom row). Can anyone help me with a wiring diagram for a single phase 120 hookup? What do I do with the ground wire?
Thanks
New Fresh Start
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top