Router Forums banner
1 - 1 of 3 Posts

· Registered
120 Posts
I've used a Wolfcraft table for a few years.
I found the mitre gauge a bit sloppy in the slot so peined the bar oved to get a better fit.
I found the fence a bit low for some of my work so made a higher one out of 3/4" plywood.
I prefere proper feather boards instead of the plastic hold down clips that fit the table.
It will do OK for me until I can buy a Rout-R-Lift to go in a home made table in the future.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.