Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi everyone.
So far I have been using my small collection of bits (15-20 pieces) with all materials, mostly pine and birch ply, but also limited work with:
-melamine coated particle boards
-plexiglass and soft plastic

I am planning to start building up a collection of branded bits, and my question is: is it a good practice to have a set of bits dedicated only for natural wood and another (cheaper) set for ply, melamines, plastic etc? Also, the same question goes for table saw discs.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top