Router Forums banner
1 - 1 of 1 Posts

· Marine Engineer
Doug
Joined
·
4,962 Posts
Woodline bits have done alright by me so far. I have a raised panel door set that I bought at a show a while back, and I can't complain about it! Have also had reasonably good luck with Pricecutter.com, have a lock-miter bit and some spirals from them.

Oldham viper, whiteside, and Amana round out my suppliers.

Have a set of cheap-o's that was given to me as a gift. I wouldn't have bought them myself, but surprisingly they really aren't that bad. Hone the edges with a diamond stone and they cut pretty well, only gripe is they are 1/4 in shank.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top