Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
146 Posts
Bought a very nice used Woodtek Router table with porter cable router, trying to cut slots but every time I run a pass and then test again it has got lower, the bit is tight, but it seems the up and down mechinism is moving, very frustrating, can't use if I can't depend on it staying at the height I SET IT.
What model PC router are we talking about?
Is it in a lift or mounted directly underneath the table?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top