Router Forums banner
1 - 1 of 13 Posts

· Registered
15,464 Posts
Tim Clement, a local custom chairmaker, uses vacuum clamping on his large CNC setup. He's routed a grid of channels into his spoilboard, lays out an appropriate 'circle' of round profiled 'O' ring cord material*...closed loop obviously...then lays his material to be carved on top. Turns on the vacuum and away he goes.


Like this...
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.