Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi
Just wondering if anyone can help out with a project I would like to do. I am using Autodesk Fusion 360 and trying to rout out the water areas on a world map. So far I cannot find any map that I can use to plug into Fusion 360 and then sort the Manufacture side of it to produce gcode for my router. Does anyone have any ideas/suggestions?
 

·
Registered
Joined
·
2,045 Posts
Joe while I can't help you with that I can welcome you to the forum. We do have a fair number of accomplished CNCers so you'll likely have your answer shortly with any luck.
 

·
Administrator
David - Machinist in wood
Joined
·
4,322 Posts
I've got this one, inspired by HJ's map in the post above when he originally shared that project. I just haven't cut one yet although I'll probably use F360 for the project when I do decide to cut one or two.

Map World Ecoregion Atlas


David
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top