Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
580 Posts
Discussion Starter · #1 ·
I re-did the carving paying better attention to ensure a straight blank and carving depth (like I should have the first time). A completely different result. Really like the pattern and the final result.

Dimensions are 10" x 11" x 1 5/16" maple and walnut. Three coats of poly. When fully hardened I'll finish up with some steel wool.
 

Attachments

·
Registered
Mike
Joined
·
3,940 Posts
Looks like you got some nice detail in that carve. Nice model!
 
  • Like
Reactions: Herb Stoops

·
Registered
Joined
·
580 Posts
Discussion Starter · #5 ·
Thanks all.

Mike, I am very happy with this model. I was concerned with the wing pattern. It has 4 different layers for depth so I was worried about the last layer losing detail but it worked out well. Pattern was carved at 5/16" and retained the detail well.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top