Router Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I just bought a used ZenBot 24x24. Using Vcarve Pro with Mach3. I have managed to get the machine to understand little of what I try to tell it. I know nothing and no one I have found in my rather remote area uses this combination. I will be asking lots of questions.
 

·
Official Greeter
Joined
·
18,811 Posts
Welcome to the forum, Dennis.

I would suggest you place an particular questions in the CNC section of the forum. many readers only look in their section of interest.
 
1 - 2 of 2 Posts
Top