Jewelry Hangers for Jewelry Armoire
I am trying to finish up an Jewelry Armoire. The sides are swing out doors that are going to hold Jewelry Hangers to hold necklaces and/or braclets. Attached are two pictures. The question is do you think that 10 degrees is enough angle to keep necklaces or braclets from falling off when closing the door or when opening the door. I made a little jig to hold the hanger at 10 degrees and cut half inch holes. The hangers are one quarter inch oak dowel and the length is 1.25 inches. That leaves about three quarters of an inch to hand jewelry on.
Do you think 10 degrees is enough or should I go to 15 degrees?