Help with Delta arbor wrench
I picked up a Delta contractor saw at an auction a few weeks ago. Its a 34-444, about 19 years old. I had to go back today and locate the miter guide, blade guard assembly, and what I think was the original 7/8" open end arbor wrench. So far so good, but....the wrench won't reach the flats because the gap between the blade washer and arbor mount (is that the right term?) is so narrow. I measured the wrench and it is 1/8" thick. Does this sound right or perhaps did the previous owner change the blade washer? If someone could measure their arbor wrench I sure would appreciate it.