VinceWNWonders, A Great Tool - Router Forums
LinkBack Thread Tools Display Modes
post #1 of 3 (permalink) Old 04-13-2012, 04:04 PM Thread Starter
Registered User
Join Date: Jun 2011
Country: United States
First Name: Jerry
Posts: 2,645
Default VinceWNWonders, A Great Tool

The drill arrived today and I tried it in the shop by sanding the profiles in the faces of a couple of picture frames that I am working on. The tool worked as well as I had hoped it would. If you need a tool that will allow you to get into those tight places, this is the tool for most of those needs. Vince says that his primary market is the "Turners" and for their need to sand inside of such things as bowls. I am not one of those type of woodworkers yet, but I have been needing to sand the faces of the picture frames that I make. These frames have profiles cut in their faces with the router and sanding in the profiles by hand is not a fun part of the construction of the frames, I think that Vince's drill and/or sanding device will take care of the issue.

Colorado City, TX
Jerry Bowen is offline  
Sponsored Links
post #2 of 3 (permalink) Old 04-13-2012, 07:52 PM
Official Greeter
jw2170's Avatar
Join Date: Jan 2008
Country: Australia
First Name: James
Posts: 18,460
Send a message via Skype™ to jw2170


I have a similar set to clean up the inside of the bowls cut in the template jig.

Sydney, Australia

I don't mind if other members disagree with my comments.
I don't profess to know everything, and I may learn something new.

"Never attribute to malice that which is adequately explained by stupidity."

jw2170 is offline  
post #3 of 3 (permalink) Old 04-14-2012, 07:44 AM Thread Starter
Registered User
Join Date: Jun 2011
Country: United States
First Name: Jerry
Posts: 2,645

Hi James,

I did learn real quick not to overheat things when using the tool as the heat will cause the adhesive that holds the pads and/or sanding discs togethr to break down. This is not a problem or fault of the tool, just a matter of common sense when you understand what is happening.

Colorado City, TX
Jerry Bowen is offline  

Quick Reply

Register Now

In order to be able to post messages on the Router Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Similar Threads
Thread Thread Starter Forum Replies Last Post
Suggest a new tool prefix Mark Power Tool Manuals 11 03-09-2014 10:25 AM
Wooden Tool Chess bobj3 The Bargain Bin 0 07-08-2011 09:00 AM
The Marvel 3 in 1 tool from MLCS: base plate and table mount advice please loninappleton Table-mounted Routing 4 07-10-2010 08:32 PM
can't find rounding hand tool frankjay02 Tools and Woodworking 3 10-15-2009 10:43 AM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome