Dust Collection Hose Mod
I found the following tip while browsing through the May/June 1998 Issue of Today's Woodworker Magazine.
I hope it will provide some inspiration for any of you that need to make some mods to your dust collection hoses so they will fit your machines.
Note: I have done something similar using the same basic setup as depicted in the picture. I needed to expand the PVC, so after making the cuts in the PVC, I used a heat gun to soften the plastic so it would spread and fit over a slightly larger dust port. Then I taped it and put a clamp on it to keep it secure.
That's my story and I'm stickin' to it!
Last edited by MT Stringer; 01-03-2015 at 07:27 PM.