I have had the Incra router table fence for some time and have been more pleased each time I use it. I got the 25" LS about five years ago and a couple of years ago I sent for the base mount kit to put it on my table saw. It has been a blessing to use. To be able to make the same cut after changing the fence setting and going back with complete accuracy. Moving the bridge up to the router table on the left side and than back to the table saw fence stops and it still being on the money. The fence has tracks in the top and the front for attaching add on's. Where my saw sits there is a little room to the right so the fence can be open to it's full width and have room for the positioner.
Yes it takes up more room the a regular fence but the cuts that you can make with it is worth any inconvenience that you may have. As far as being tough and solid it is. Even when cutting big and heavy pcs.
So it may not be for every one but I think that after using one for a while most people would love it. I would probably not want to go back to my old fence and I did have a good fence.
Hope this helps, Bob
Last edited by Robert Potter; 04-10-2011 at 09:59 PM.