I'm going for broke that someone here might have experience or insight with this..
So I wish to use resin to create a small symbol or shape in finished plaster on a wall. To aid this, the project will likely be done on a roughly 6" x 6" cut out piece of finished plaster wall, placed back on the wall in a space made and jointed up etc suitably.
The purpose of the resin is to look clean and seamless on the wall, allow a light in the back to illuminate the resin, and basically, and ELLABORATELY! replace the physical light switch.
Any thoughts or tips on how this might be achieved with high precision and a seamless clean finish would be very much appreciated.
So I wish to use resin to create a small symbol or shape in finished plaster on a wall. To aid this, the project will likely be done on a roughly 6" x 6" cut out piece of finished plaster wall, placed back on the wall in a space made and jointed up etc suitably.
The purpose of the resin is to look clean and seamless on the wall, allow a light in the back to illuminate the resin, and basically, and ELLABORATELY! replace the physical light switch.
Any thoughts or tips on how this might be achieved with high precision and a seamless clean finish would be very much appreciated.
