Router Forums banner

I did use a router, honest.

4K views 22 replies 20 participants last post by  sunnybob 
@sunnybob,

Bob, instead of trying to gild the lily, perhaps you could utilise the time to perfect a flick that would pass the blade through the mullet of a repellant adolescent refugee from a zit-fest? Now that would be cool.
@Bushwhacker,
David, you mean you have knife open-carry states over there? How did Crocodile Dundee get by unhindered?
 
Bob, if you have access to an oxy-acetylene torch, get hold of some case-hardening compound. You will be able to harden the outside of the steel to a reasonable degree. Not as good as the whole hardening and tempering bit, but will give you some additional longevity. Do it before final cleaning and polishing of the blade, as there may be some discolouration - in fact, try it on a piece of offcut from you bar first.
Not sure if you can get case-hardening compound in Cyprus, but will be available from the UK.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top