G’day Ellsworth

Welcome to the router forum.

Thank you for joining us

 

Hi Ellsworth,

I'm pretty sure the 7539 is capable of above table adjustment via an optional crank/knob. Unless for some reason you can't use the built in "lift", you really don't need to spend the money.

Mike

 

Table mounted 7539



Now that is good news! I will have to take the plate off of it and see. I got the router from my brother and didn't know much about it other than it worked fine when I built a kitchen pantry for my wife. I used it to make raised panel doors.

Thanks for the tip, that will definitely save some money.

ells

 

The one thing to check is if it will allow you to change bits without removing it from the table. Might not be a big thing if it is plate mounted.

 

Hi
No need to remove the router from the table or lift the router out of the table with the item below.

Heavyweight and Precision Router Table

======

========

 

I have had the same setup for a number of years and have been very happy with it.

Tom:dance3: