Router Forums banner
1 - 2 of 16 Posts

· Registered
8,958 Posts
The idea of a loose insert plate with a router motor turning 18,000 rpms kinda scares me. The shroud sounds great as my setup does not pull sawdust worth a hoot.
Do you have DC both above and below the table? That is a must ,but router tables are a hard one to confine all the sawdust. Just about the time you think that you have done it, the next set up allows the chips to fly a different direction. I think making rabbets and dados are the hardest to contain, some people drill holes in the table top to pull the dust down, But I have found that is only a moderate solution as the chips find a way to fly.
1 - 2 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.