Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
724 Posts
Hi Rev A,
you can chuck the opposite end of the threaded rod in a cordless drill, and use that for rapid gross movements up or down, then use the large star knob for fine adjustments. You might have to turn the jack side on, so you can access both ends of the threaded rod from the same side of the table.
Interesting that, unlike most car jacks, your threaded rod has opposite turns of thread from the central unthreaded part, like the screws on wooden hand-screws.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top