Router Forums banner

1/16" Round Over Bit

8169 Views 29 Replies 17 Participants Last post by  subtleaccents
I was glancing through an article on roundover bits and it mentioned using a 1/16" roundover bit to soften edges. I have usually done this with a just a fine sanding block. Should I get the 1/16" roundover bit for this?
1 - 2 of 30 Posts
Good old Stanley No 194 - Oops! I'm showing my age!


See less See more
Re previous post - I realise that it gives a bevel and not a roundover, but its sometimes a good start for softening the sharp edges.
  • Like
Reactions: 1
1 - 2 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.